DIGITIZE SEBB-6/24 Podręcznik użytkownika - Strona 7

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Kontroler DIGITIZE SEBB-6/24. DIGITIZE SEBB-6/24 11 stron.

Select the quick charge rate, for the type of batteries being used. The charge

rate is always set to the 4 amp rapid charge for the 28 amp/hour or larger

capacity batteries. See DWG 3.

2.6 SEBB-6/24 to SYSTEM 3505 SETUP

The SEBB-6/24 is connected to the SYSTEM 3505 using the 6 foot red and

black cable, with one end stripped. This cable will provide power to the

SYSTEM 3505 during a power failure. To connect the SEBB-6/24 to the

SYSTEM 3505 unit, screw the Molex 2 position connector into the back of the

SEBB-6/24, the stripped ends are then attached to the terminal block located on

the rear panel of the 3505 unit. Refer to DWG 4.

SEBB-6/24

Remove the Molex 2 position connector from the terminal block of the

SYSTEM 3505. Secure the red wire to the positive (+) side of the terminal and

the black wire to the negative (-) side of the terminal. Reattach the Molex 2

position connector to the terminal block, on the back of the SYSTEM 3505.

Refer to DWG 5.

DIGITIZE, INC. 700256-0001 REV. C 01/06

Specifications Subject to Change Without Notice

SEBB-6/24 USER MANUAL

2.5.1 DWG 3

2.6.1 DWG 4

SYSTEM 3505