Cisco CE 2000 Platform SCE 2000 4xGBE Skrócona instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Sprzęt sieciowy Cisco CE 2000 Platform SCE 2000 4xGBE. Cisco CE 2000 Platform SCE 2000 4xGBE 29 stron. Service control engine

Drukuj stronę

Revised: September 17, 2012, OL-26789-01

This document supports all 3.8.x releases.

Note

Preparing for Installation

This section contains warnings, tools and part information, and site preparation details.

Warning

This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any

equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for

preventing accidents.

Warning

Only trained and qualified personnel should install, replace, or service this equipment.

Warning

Read the installation instructions before you connect the system to its power source.

Warning

This unit is intended for installation in restricted access areas. A restricted access area is where access can only

be gained by service personnel through the use of a special tool, lock and key, or other means of security, and is

controlled by the authority responsible for the location.

Warning

Voltage is present on the backplane when the system is operating. To reduce risk of an electric shock, keep hands

and fingers out of the power supply bays and backplane areas.

Warning

Do not work on the system or connect or disconnect cables during periods of lightning activity.

Warning

Before you begin the installation of the SCE 2000 platform, read the

for the Cisco Service Control Engines (SCE)

Site Preparation

• Print out and have accessible the

Installation and Configuration

• Verify that the power service at the site is suitable for the SCE 2000 chassis.

• Verify that there is at least a two inch (5 cm) clearance on both sides of the SCE 2000 and five inches (12.7 cm) at the rear

for adequate airflow for the inlet and exhaust vents.

document.

"Cisco SCE 2000 GBE Installation

Guide, to record information about this installation.

Regulatory Compliance and Safety Information

Checklist", found in the

Cisco SCE 2000 GBE