Cisco Cisco ASA Series Pierwsze kroki - Strona 16

Przeglądaj online lub pobierz pdf Pierwsze kroki dla Sprzęt sieciowy Cisco Cisco ASA Series. Cisco Cisco ASA Series 31 stron.
Również dla Cisco Cisco ASA Series: Montaż i połączenie (12 strony), Montaż i połączenie (6 strony)

Drukuj stronę

Factory Default Configurations

c) Save the installer to your computer, and then start the installer. The ASDM-IDM Launcher opens

automatically after installation is complete.

d) Enter the management IP address, the same username and password (blank for a new installation), and

then click OK.

Step 3

To use Java Web Start:

a) Click Run ASDM or Run Startup Wizard.

b) Save the shortcut to your computer when prompted. You can optionally open it instead of saving it.

c) Start Java Web Start from the shortcut.

d) Accept any certificates according to the dialog boxes that appear. The Cisco ASDM-IDM Launcher appears.

e) Leave the username and password fields empty (for a new installation), and click OK. With no HTTPS

authentication configured, you can gain access to ASDM with no username and the enable password,

which is blank by default. Note: If you enabled HTTPS authentication, enter your username and associated

password. Even without authentication, if you enter a username and password at the login screen (instead

of leaving the username blank), ASDM checks the local database for a match.

Factory Default Configurations

The factory default configuration is the configuration applied by Cisco to new ASAs.

• ASA appliances—The factory default configuration configures an interface for management so that you

• ASA on the Firepower 9300 chassis—When you deploy the standalone or cluster of ASAs, the factory

• ASAv—Depending on your hypervisor, as part of deployment, the deployment configuration (the initial

• ASASM—No default configuration. See

For appliances and the ASA on the Firepower 9300 chassis, the factory default configuration is available only

for routed firewall mode and single context mode. For the ASAv, you can choose transparent or routed mode

at deployment.

Note

In addition to the image files and the (hidden) default configuration, the following folders and files are

standard in flash memory: log/, crypto_archive/, and coredumpinfo/coredump.cfg. The date on these files

may not match the date of the image files in flash memory. These files aid in potential troubleshooting;

they do not indicate that a failure has occurred.

CLI Book 1: Cisco ASA Series General Operations CLI Configuration Guide, 9.5

can connect to it using ASDM, with which you can then complete your configuration.

default configuration configures an interface for management so that you can connect to it using ASDM,

with which you can then complete your configuration.

virtual deployment settings) configures an interface for management so that you can connect to it using

ASDM, with which you can then complete your configuration. You can also configure failover IP

addresses. You can also apply a "factory default" configuration if desired.

start configuration.

Access the ASA Services Module Console, on page 4

Getting Started