Digitone ProSeries 3 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria telefoniczne Digitone ProSeries 3. Digitone ProSeries 3 16 stron.

Programming

Connecting your Telephone to the TEL Jack of the ProSeries 3 Blocker

Testing your connection to the DPS3

With the ProSeries 3 Blocker powered up, go off-hook with the phone you are using in

the TEL port. See if the DPS3 shows the Call Progress Timer on the lower line of the

display, ex. 0:01, 0:02, etc. before attempting programming. If so, Hang-up.

Entering Programming - Press and hold the Program button for 3 seconds until you

see the

RED

LED light, then Release button, see "Program Mode", then "Pick Up

Phone", and wait for the BEEP. Preferably, you can take your phone off-hook, get

the dial tone and dial ## or *** to enter programming faster. In both cases, the

phone must be connected to the TEL port and not in parallel to the DPS3.

Programming User Changeable Settings

Caller ID Standard

Code 16#*

– Bellcore FSK Caller ID is used for landline

telephony in North America (USA, Canada, Mexico) and other countries (European

Union) that utilize FSK or ETSI Standards. DTMF is also available using

Code 17#*

enable: enter programming and when "Enter Code" displays: enter 17#*.

Spoofed Exchange Calls –

Code 20

Callers using spoofed exchanges can be blocked

by setting any string of 3 numbers they repeat in order to ring your phones like: "555".

To enable blocking of a spoofed number (up to 30), enter programming and when

"Enter Code" displays: enter 20 followed by the Exchange number you want to block,

then #### then the * key to store it. EX: 20 555 #### * blocks the 555 exchange.

Spoofed Last 4 Digits - Callers spoofing the last four digits of a number can be

blocked by using 20 [exchange] # # # # * to block a caller who changes these

numbers for each call, like Ex: 602-555 1234, 602-555 1235, etc. Just enter Code 20

followed by the exchange, then # for wildcard blocking any number, or enter a specific

number range like: 602 555 12##, 602 555 123#, 602 555 ###2.

LCD Back Lighting Timer

Code 27

– You can adjust the LCD back light display time

from the default of 10 seconds. Press and hold the Program Button for 3 seconds

until you see "Program Mode", then "Pick Up Phone", when the prompt for "Enter Code"

displays, enter 27 then the number of seconds you want the LCD to light, followed by *

key. EX: 2715* is 15 seconds (1 second up to 60 seconds), 2700* is OFF.