Cisco GS7000 Instrukcja instalacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt sieciowy Cisco GS7000. Cisco GS7000 13 stron. Gainmaker node forward local injection module
Również dla Cisco GS7000: Podręcznik konserwacji (15 strony), Rozwiązywanie problemów (4 strony), Instrukcja rozwiązywania problemów (12 strony)

Local Injection version of the 1x2 Redundant Forward Configuration Module.

F-type bulkhead RF connector assembly for port F2 (or optional port F1) on node

housing lid.

Two 1.5 dB pads for the FWD I/S pads on the GS7000 Node RF amplifier

assembly.

Note: Pads are not included in upgrade kit. Obtain those from your normal on-

hand node accessories.

Installing the FLI Module

Note: This example uses port F2 for the external RF source. This should represent

the majority of installations, since port F1 is most commonly used as the input port

for the optical fibers.

Important: For complete information on opening/closing the node and working on

components inside the node, refer to Model GS7000 GainMaker Scaleable 4-Port Node

Installation and Operation Guide, part number 4013584.

Complete the following steps to install the FLI Module in the node.

Open the node housing.

Place the FLI Module in the RCVR 4 position on the OIB in the node housing lid

and insert the module until it is connected to the OIB.

Note: If an existing receiver module is in the RCVR 4 position, it must be moved

to a different RCVR position. Refer to Receiver/Transmitter Module Removal

and Replacement.

Tighten the module retaining screws to secure the module in the node. Torque

the screws from 25 to 30 in-lbs (2.8 to 3.4 Nm).

4019330 Rev C

FLI Module Installation