Cisco IAD2430 Series Przegląd - Strona 11
Przeglądaj online lub pobierz pdf Przegląd dla Sprzęt sieciowy Cisco IAD2430 Series. Cisco IAD2430 Series 16 stron. Integrated access device
Również dla Cisco IAD2430 Series: Podręcznik przeglądowy (13 strony), Skrócona instrukcja obsługi (34 strony)
Drukuj stronę
Chapter 1
Overview of Cisco IAD2430 Series IADs
Configuration Methods
You can configure a Cisco IAD2430 series IAD automatically using the Simple Network-Enabled
Auto-Provision (SNAP) option, or you can configure theCisco IAD2430 series IAD manually using
several methods listed in
Automated Configuration
If your Cisco IAD2430 series IAD was ordered with the SNAP option, no on-site configuration is
required. When the Cisco IAD is powered on and connected to the WAN, the SNAP application
downloads the applicable configuration files automatically. For additional information about SNAP, see
the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122t/122t8/ftapiad8.htm
The SNAP option is not available on the Cisco IAD2435 IAD.
Note
Manual Configuration
When you install a Cisco IAD2430 series IAD, see the
the initial configuration. This configuration sets the basic communication parameters. After the Cisco
IAD is operating and able to communicate, use the procedures in the
Configuration Guide
configuration.
You can use any of several manual methods for configuring a Cisco IAD2430 series IAD:
•
•
•
•
•
Interfaces and Service Capabilities
Table 1-1
the following.
•
•
•
OL-4234-06
"Manual Configuration" section on page
to configure the specific services and functions, or to make changes to the existing
System configuration dialog
Configuration mode—Cisco IOS software command-line interface (CLI)
setup command facility—Remote configuration through a LAN or WAN
SNMP-based application—CiscoView or HP OpenView
HTTP-based configuration server—Provides access to the CLI from a web browser
describes the various physical ports and the services that each port type supports, including
Two administrative ports—One console and one auxiliary.
Note
The Cisco IAD2435 IAD provides a connection to the terminal or PC for software
configuration or troubleshooting. The console port may be configured as a virtual auxiliary
port for dial backup and remote management.
One or two 10/100BASE-T LAN ports.
One or two Fast Ethernet ports.
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
Interfaces and Service Capabilities
1-11.
"Power-On Procedure" section on page 4-1
Cisco IAD2430 Series Software
for
1-11