Digitrax DN166PS Skrócona instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Kontroler Digitrax DN166PS. Digitrax DN166PS 8 stron. Complete train control

Parts List

1 DN166PS Mobile Decoder

1 Instruction Sheet

1 8 Pin Digitrax easy connect to 8 pin medium plug Track, Motor, and

Function Harness

See the Digitrax Decoder Manual for complete decoder test procedures, instal-

lation instructions, programming and technical information. Digitrax manuals

and instructions are updated periodically. Please visit www.digitrax.com for the

latest versions, technical updates and additional locomotive-specific installation

instructions. CAUTION: Programming and layout track must not exceed

16V when using this decoder.

Carefully remove the locomotive shell from the frame following the

manufacturer's instructions. Notice the orientation of the shell to the frame

so that you can reinstall correctly.

The DN166PS uses the DNWHPS Digitrax Easy Connect 8 Pin Harness

System which consists of a 2.0" harness that has a Digitrax 8-pin plug on one

end and a DCC medium plug on the other. Remove the jumper plugs from

the DCC medium socket on the factory light board and plug in the DCC plug

end of the harness.

For a wired connection in locos that do not have a DCC medium plug, cut the

wires from the DCC medium plug and attach them as described. On the 8 Pin

Track, Motor and Function Harness solder the Red and Black track leads to

the locomotive track power connections. Next solder the Orange and Gray

motor leads to the isolated motor connections. Motor connections must be

isolated from the track connections.

Connect any function leads that are to be used for e.g. lights. Insulate any

unused function leads so they cannot short to the locomotive frame or track

power.

Inspect the installation before testing and replacing the shell. In particular

be sure that wires are correctly soldered and routed and that the motor leads

are not shorted to the frame or track.

Replace the loco shell. You are now ready to run your locomotive. The

DN166PS is factory programmed to address 03. You can easily customize

the address and other features. See section "Customizing Your Decoder" that

follows.

Caution: To prevent damage to your decoder and locomotive, track voltage

used during operation must not exceed the operating parameters of the

locomotive and its lighting system in which the decoder is installed (typically

this is 12V DC). For most N scale layouts, Digitrax recommends using 14 volts

DCC or less for operation to avoid damage to the locomotive shell, lamps and

decoder.

— 2 —