Digitrax DN136D Podręcznik użytkownika - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Zabawka Digitrax DN136D. Digitrax DN136D 8 stron. Complete train control

Parts List

1 DN136D Mobile Decoder

1 Instruction Sheet

1 DNWH Digitrax Easy Connect 8 Pin Harness

See the Digitrax Decoder Manual for complete decoder test procedures, instal-

lation instructions, programming and technical information. Digitrax manuals

and instructions are updated periodically. Please visit www.digitrax.com for the

latest versions, technical updates and additional locomotive-specific installation

instructions. CAUTION: Programming and layout track must not exceed

16V when using this decoder.

Carefully remove the locomotive shell from the frame following the

manufacturer's instructions. Notice the orientation of the shell to the frame

so that you can reinstall correctly.

The DN136D uses the DNWH Digitrax Easy Connect 8 Pin Harness System

which consists of an approximately 4.5" harness that has a Digitrax 8 Pin

plug on one end and wires on the other. The harness allows the decoder to

be easily installed in a variety of locomotives. The ends of the wires of the

harness are wired to the motor connections, power pickup connections and

the lights as shown in Figure 1 below.

Plug the 8 Pin plug on the DNWH harness into the socket on the decoder

The plug is notched to fit easily into the socket in only one orientation.

Replace the loco shell. You are now ready to run your locomotive. The

DN136D is factory programmed to address 03. You can easily customize the

address and other features. See section "Customizing Your Decoder" that

follows.

Figure 1: DN136D Wiring

Diagram

— 2 —

Warning: to prevent decoder

damage, be sure the motor

brushes are properly isolated

before applying power.