argon audio tt-2 Podręcznik użytkownika - Strona 10
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Gramofon argon audio tt-2. argon audio tt-2 12 stron.
Również dla argon audio tt-2: Instrukcja obsługi (12 strony), Instrukcja obsługi (12 strony)
Drukuj stronę
Changing replay speed
To play records at 45 r.p.m. first remove the platter (5). Using the accessory tool
provided (3a), hook the belt (3) over the larger diameter part of the motor pulley (2).
Refit the platter. To revert to 33,33 r.p.m. repeat the proceedings using the smaller
step on the pulley.
Fitting and connecting the cartridge
** All cartridges with half inch mounting holes can be fitted. Leaving the needle's
protection cover on, fit the cartridge to the headshell using the screws supplied with
the cartridge by passing one screw through each slot in the headshell (21). Do not
tighten the nuts yet.
Connect the tonearm wires to the cartridge pins as follows:
white
left channel positive (L+)
red
right channel pos. (R+)
green
right channel return (R -)
blue
left channel return (L -)
The full sound quality of the Argon Audio TT2 can only be achieved if the cartridge is
correctly adjusted.
If you are not well acquainted with the adjustment of cartridges you are advised to call
upon the willing help of your Argon Audio dealer to accomplish this task for you.
Adjusting the azimut
** The cartridge needle must be vertical in the record groove in
order to trace the groove wall modulations correctly.
A small screw at the bearing end of the arm allows incorrect
azimut to be corrected if your needle is not mounted exactly
perpendicular to the cartridge body (which is often the case).
Slacken off the screw just enough to be able to revolve the
arm tube without applying force. Note! Do not remove the
screw completely!
With the aid of a good magnifying glass adjust the needle until it is vertical in the
groove (i.e. perpendicular to the record's surface). Ideally this should correspond to
the top surface of the cartridge body being parallel to the record surface. When you
are satisfied that the needle is vertical retighten the screw carefully.
Under no circumstances should the arm tube be adjusted with the needle still in the
record groove! Irreparable damage may be caused to the cantilever suspension! The
arm must be lifted to make each adjustment and lowered afterwards to check it.
w w w . a r g o n a u d i o . c o m
T T 2
10