Argonaut R515 Podręcznik referencyjny - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik referencyjny dla Monitor Argonaut R515. Argonaut R515 20 stron. Led marine monitor

Wiring

NOTE: THE POSITIVE WIRE IS RED AND THE NEGATIVE WIRE IS BLACK.

The standard input cables include VGA, DVI, RCA/S-Video, and DC Power cable. All cables exit the rear

of the monitor through a waterproof cable clamp. Note that the input cable ends are not waterproof and

should be placed or installed in a dry, protected area. DO NOT PULL CABLES TIGHT TO

PREVENT EXCESS STRAIN AND POSSIBLE BREAK IN CABLE CLAMP SEAL. Contact your

Argonaut Dealer if additional cable lengths are required in excess of standard provided.

Power

The R515/R515-HT monitor is designed for 12 Volt power input through an Argonaut supplied power

regulator. The correct regulator should be specified at time of ordering for connection to either a 12 volt or

24 volt system. The regulators accept a range of voltage (either 9 to 18V or 19 to 32V) and provide a steady

12 volts to the monitor.

NOTE: ANY DIRECT CONNECTION OF THE MONITOR TO 12 OR 24

VOLT POWER WITHOUT FIRST RUNNING THROUGH THE ARGONAUT SUPPLIED

REGULATOR COULD PERMANENTLY DAMAGE THE MONITOR AND VOID YOUR

WARRANTY. DO NOT CONNECT THE REGULATOR TO VOLTAGE EXCEEDING THE

SPECIFIED RANGE AS THIS WILL DAMAGE THE REGULATOR. DO NOT CONNECT THE

MONITOR DIRECTLY TO A/C POWER (110-220V) POWER AS THIS WILL DAMAGE THE

DISPLAY AND COULD CAUSE A FIRE.

PLEASE MAKE SURE TO AVOID IMPROPER

CROSSING WIRES (POSITIVE TO NEGATIVE) AS THIS CAN DAMAGE THE DISPLAY

ELECTRONICS.

Care & Precautions

Care: The LCD has a special coating to prevent reflection. Clean with soft clean cloth dampened with fresh

water to remove residue. Follow up with alcohol and lens cleaning wipes if desired. If water has collected

in screen bezel, wipe dry before covering/storing. NOTE: DO NOT ALLOW SALT WATER

DEPOSITS TO REMAIN ON GLASS SURFACE FOR EXTENDED PERIODS (REMOVE SALT

DEPOSITS WITH FRESH WATER).

LONG TERM SALT DEPOSITS MAY CAUSE

PERMANENT DAMAGE TO THE SCREEN SURFACE. We recommend our optional custom fit

canvas cover to protect the display for extended periods in direct sunlight. Additional Precautions:

Do not operate in temperature extremes (below 32°F (0° C) or above 104 °F (40° C)). Do not put

pressure or contact directly on screen surface. Do not connect directly to power source without using

the regulator supplied. Do not reverse power wires. Do not expose to submersion or high pressure

water. Do not pull or strain cabling as this can break the cable clamp seal.

CAUTION: DO NOT EXPOSE THE BACK SIDE CABLING FOR R515 TO DIRECT WATER

CONTACT AS THE CABLES ARE NOT SEALED WATERPROOF. THE R515-HT MODEL

DOES HAVE SEALED WATERPROOF CABLES.

Page