Digitron PM-150 Podręcznik

Przeglądaj online lub pobierz pdf Podręcznik dla Przyrządy pomiarowe Digitron PM-150. Digitron PM-150 2 stron.

Drukuj stronę

Model:

Sensor type:

Operating range:

Connector Type:

Units:

Operating Temperature:

Accuracy of Unit Only:

Note: FS=Full Scale LSD= Least Significant Digit (Full range of the unit to be used for both low & high scale calculations)

Particular care should be taken not to over pressure the device as this may rupture the sensor membrane. This is

not covered by the manufacturers warranty.

Note: The differential/gauge instrument will only measure relative pressures i.e positive pressure applied to the

positive port or negative pressure applied to the negative port.

Instrument Application

The PM-150 is suitable for the measurement of differential pressure.

Instrument Operation

The instrument requires two AA or equivalent cells. These are not supplied with the unit.

When the batteries require changing the following symbol will be displayed:

Please ensure the screws holding the battery compartment are firmly tightened when inserting or replacing batteries

to ensure the IP67 rating is maintained.

Press ON key to turn unit ON. Press OFF key to turn unit OFF.

The unit will switch OFF automatically after 12 minutes, unless any key is activated.

To disable automatic switch off, hold

switch-off function until the unit is switched off.

Out of Range

If pressure exceeds the scale range Out will appear on the display.

Zeroing

In order to achieve maximum accuracy, it is recommended to zero the instrument in the orientation it will be used

before taking any measurements.

Ensure both ports are open to atmospheric pressure, if indicated pressure is within 3% of full scale of the factory

calibrated zero, press 0.0 key which will adjust the reading to zero.

Hold Function

To enable the Hold Function, press the "Hold"

Hose fitting

The input port(s) on the instrument are designed to accept a hose with 8mm Interior Diameter and 1mm wall. The

hose is fitted by pushing the hose onto the port, an additional clamp fitting may be used to ensure secure fitting.

Smoothing mode

Press ═ key and the instrument continuously averages the last four measurements to give a more stable reading on

the display. Press ═ again to return back to normal settings.

Units of pressure

Press

key to select required units of pressure. Chosen units will be saved when the instrument is switched off.

Back Light

PM-150

Differential

2 bar

Screw fit connector

mbar / PSI / kPa / inHg/ mHg / inH20 / mmH20

-10°C to +50°C

+20 to +50°C: 0.10% of RDG +0.10% of FS + 1 LSD

-10 to +20°C: 0.15% of RDG +0.15% of FS + 1 LSD

All ± 1 LSD Digit ( 0.1˚C Low scale; 1˚C High scale )

Negative pressure: 0.3% reading + 0.3% full scale

Key when the unit is being switched on. This will disable the automatic

button, press again to release the Hold Function.