Cisco RSP7000 Instalacja - Strona 6
Przeglądaj online lub pobierz pdf Instalacja dla Sprzęt sieciowy Cisco RSP7000. Cisco RSP7000 26 stron. Upgrade kit in the cisco 7000 series routers
Również dla Cisco RSP7000: Instrukcja instalacji i konfiguracji (48 strony)
Drukuj stronęInstallation Prerequisites
Installation Prerequisites
Before you begin this installation, review the safety guidelines in this section to avoid injuring
yourself or damaging the processor module.
Safety Guidelines
Following are safety guidelines that you should follow when working with any equipment that
connects to electrical power or telephone wiring.
Electrical Equipment Guidelines
Follow these basic guidelines when working with any electrical equipment:
•
•
•
•
•
•
Telephone Wiring Guidelines
Use the following guidelines when working with any equipment that is connected to telephone
wiring or to other network cabling:
•
•
•
Preventing Electrostatic Discharge Damage
Electrostatic discharge (ESD) damage, which can occur when electronic cards or components are
improperly handled, results in complete or intermittent failures. Electromagnetic interference (EMI)
shielding and connectors are integral components of the carrier. Use a preventive antistatic strap
whenever handling a processor module.
Following are guidelines for preventing ESD damage:
•
•
•
6 Installing the RSP7000 Upgrade Kit in the Cisco 7000 Series Routers
Before beginning any procedures requiring access to the chassis interior, locate the emergency
power-off switch for the room in which you are working.
Disconnect all power and external cables before moving a chassis.
Do not work alone when potentially hazardous conditions exist.
Never assume that power has been disconnected from a circuit; always check.
Do not perform any action that creates a potential hazard to people or makes the equipment
unsafe.
Carefully examine your work area for possible hazards such as moist floors, ungrounded power
extension cables, and missing safety grounds; correct all hazardous conditions.
Never install telephone wiring during a lightning storm.
Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations, and use caution when installing or modifying telephone lines.
Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
Always use an ESD wrist or ankle strap and ensure that it makes good skin contact.
Connect the equipment end of the strap to a captive installation screw on an installed power
supply.
Handle components by the edges only; avoid touching the board or connectors.