Cisco SCE 1000 and Skrócona instrukcja obsługi - Strona 17
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Sprzęt sieciowy Cisco SCE 1000 and. Cisco SCE 1000 and 49 stron. Service control engine 1000 2xgbe
Drukuj stronę
Step 2
Configure the subnet mask.
The current subnet mask is displayed.
To accept the displayed value, press Enter.
–
To change the value, type the desired value in the format "x.x.x.x" and press Enter.
–
Step 3
Configure the default gateway.
The current IP address of the default gateway is displayed.
To accept the displayed value, press Enter.
–
To change the value, type the desired value in the format "x.x.x.x" and press Enter.
–
Example
The following example displays a typical configuration of the IP address (10.1.5.109), subnet mask (255.255.0.0), and default
gateway (10.1.1.3).
Since the IP address and the subnet mask are related, when the IP address is changed, there is no longer a default value of the
subnet mask, and it must be entered explicitly.
Enter IP address [10.1.1.201]:10.1.5.109
Enter IP subnet mask:255.255.0.0
Enter IP address of default gateway [10.1.1.3]:
Step 2: Configuring the Hostname
The hostname is used to identify the SCE 1000. It appears as part of the CLI prompt and is also returned as the value of the
MIB-II object sysName.
The maximum length is 20 characters.
The default hostname is SCE 1000.
Specify the hostname for the SCE platform.
Step 1
The default hostname is displayed.
To accept the displayed value, press Enter.
–
To change the value, type any desired character string and press Enter.
–
Enter hostname [SCE 1000]:
Step 3: Setting the Passwords
Configure the passwords as follows:
• Set the password for each authorization level (User, Admin, Root).
• Enable/disable password encryption. When password encryption is enabled, it encrypts the previously entered passwords.
Passwords are needed for all authorization levels in order to prevent unauthorized users from accessing the SCE 1000.
Note
Admin level should be used by the network administrator. Root level is for use by Cisco technician.
Passwords must meet the following criteria:
• Minimum length — 4 characters
• Maximum length — 100 characters
• Begin with an alpha character
• May contain only printable characters
17