Cisco UBR7246VXR Instrukcja instalacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt sieciowy Cisco UBR7246VXR. Cisco UBR7246VXR 28 stron. Universal broadband router
Również dla Cisco UBR7246VXR: Skrócona instrukcja obsługi (27 strony), Podręcznik użytkownika (7 strony), Instalacja sprzętu (25 strony)

Drukuj stronę

Clock Source Overview

There are three methods used to acquire and distribute both the primary and secondary national clock

sources on the Cisco uBR7246 VXR. Using one of these three methods, the clock card can propagate a

national clock signal throughout the chassis midplane to a supported cable interface line card, thus

synchronizing communications over all cable interfaces in the Cisco uBR7246 VXR to other routers.

To use a national clock source, the cable interface line card must be one of the following models:

•

The three methods used to acquire a national clock signal are:

•

External clock sources must conform to the following minimum specifications:

•

When installed in a Cisco uBR7246 VXR chassis, the clock card operates with a Cisco uBR-MC16S or

Note

Cisco uBR-MC16E cable modem card using Cisco IOS Release 12.1(1a)T1 or later, as well as Cisco IOS

Release 12.1(2)EC1 or later. The clock card also operates with a Cisco uBR-MC28C cable modem card

using Cisco IOS Release 12.1(3a)EC1 or later. You can use other cable interface cards, such as the

Cisco uBR-MC16C, with the clock card, but these other cable interfaces will not synchronize their

downstream SYNC messages with the external clock source.

Modes of Operation

The clock card can provide timing reference to the Cisco uBR7246 VXR in a number of ways:

•

Cisco Cable Clock Card Hardware Installation Guide for the Cisco uBR7246VXR Universal Broadband Router

1-2

Cisco uBR-MC16S

Cisco uBR-MC16E

Cisco uBR-MC28C

Cisco uBR-MC28U/X

Connecting to external T1 source signals from the Public Switched Telephone Network (PSTN)

Propagating the clock signal from an active T1 connection originating on a port adapter installed in

the same Cisco uBR7246 VXR

Connecting to an external GPS receiver generating the appropriate T1 clock signal

Traceable to Stratum 1 clock signal

A Stratum 1 clock has a long-term accuracy of 10

Note

synchronizing a few master sites in a digital telecommunications network. The synchronized

signals propagate the time standard throughout the network.

Wander on the reference input must not exceed ANSI T1.101 section 7.2.2, time deviation for

Type III DS1 reference signals

Jitter must not exceed the maximum allowable specified in GR-499-CORE section 7.2 for DS1 rates

Locked to either primary or secondary signal—The clock card remains in continuous contact with

the primary and/or secondary external Stratum 1 clock source until a loss of service occurs, at which

time the clock card assumes either holdover or freerun operation. This is the normal mode of

operation for the clock card.

Chapter 1

-11

. Stratum 1 clocks are generally used for

Overview

OL-26705-01