Cisco UCS B200 M3 Uwaga dotycząca instalacji i obsługi - Strona 33

Przeglądaj online lub pobierz pdf Uwaga dotycząca instalacji i obsługi dla Sprzęt sieciowy Cisco UCS B200 M3. Cisco UCS B200 M3 36 stron. Blade server
Również dla Cisco UCS B200 M3: Instrukcja instalacji (34 strony), Uwaga dotycząca instalacji i obsługi (37 strony), Podręcznik (8 strony), Instrukcja aktualizacji (21 strony), Uwaga dotycząca instalacji i obsługi (28 strony)

S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m

If you are switching from one type of adapter card to another, before you physically perform the switch

make sure that you have downloaded the latest device drivers and loaded them into the server's operating

system. For more information, refer to the firmware management chapter of one of the UCS Manager

software configuration guides.

To install an adapter card on the blade server, follow these steps:

Position the adapter board connector above the motherboard connector and align the two adapter captive

Step 1

screws to the standoff posts on the motherboard.

Firmly press the adapter connector into the motherboard connector.

Step 2

Tighten the two captive screws.

Step 3

Removing an adapter card is the reverse of installing it. You may find it helpful when removing the

Tip

connector from the motherboard to gently rock the board along the length of the connector until it

loosens.

Figure 21

OL-26624-01

Installing an Adapter Card

Cisco UCS B200 M3 Blade Server Installation and Service Note

Memory and Performance