Cisco UCS B200 M3 Uwaga dotycząca instalacji i obsługi - Strona 8

Przeglądaj online lub pobierz pdf Uwaga dotycząca instalacji i obsługi dla Sprzęt sieciowy Cisco UCS B200 M3. Cisco UCS B200 M3 37 stron. Blade server
Również dla Cisco UCS B200 M3: Instrukcja instalacji (34 strony), Uwaga dotycząca instalacji i obsługi (36 strony), Podręcznik (8 strony), Instrukcja aktualizacji (21 strony), Uwaga dotycząca instalacji i obsługi (28 strony)

Powering Off Blade Servers Using the Power Button

You can also shut the server down remotely using Cisco UCS Manager. For details, see the Configuration

Tip

Guide for the version of Cisco UCS Manager that you are using. The configuration guides are available

at the following URL:

configuration_guides_list.html

Procedure

Step 1

For each server in the chassis that you want to power off, check the color of the Power Status LED.

• Green indicates that the server is running and must be shut down before it can be safely powered off. Go to Step 2.

• Amber indicates that the server is already in standby mode and can be safely powered off. Go to Step 3.

Step 2

Press and release the Power button, then wait until the Power Status LED changes to amber.

The operating system performs a graceful shutdown and the server goes to standby mode.

To avoid data loss or damage to your operating system, you should always invoke a graceful shutdown of the

Caution

operating system.

Step 3

(Optional) If you are shutting down all blade servers in a chassis, disconnect the power cords from the chassis to completely

power off the servers.

Step 4

Remove the appropriate servers from the chassis.

Removing a Blade Server

Using UCS Manager, decommission the server before physically removing the server. To remove a blade server from the chassis,

follow these steps:

Procedure

Step 1

Loosen the captive screw on the front of the blade.

Step 2

Remove the blade from the chassis by pulling the ejector lever on the blade until it unseats the blade server.

Step 3

Slide the blade part of the way out of the chassis, and place your other hand under the blade to support its weight.

Step 4

Once removed, place the blade on an antistatic mat or antistatic foam if you are not immediately reinstalling it into another

slot.

Step 5

If the slot is to remain empty, install a blank faceplate (N20-CBLKB1) to keep dust out of the chassis.

http://www.cisco.com/en/US/products/ps10281/products_installation_and_