Cisco 7513 Series Instrukcja wymiany - Strona 16

Przeglądaj online lub pobierz pdf Instrukcja wymiany dla Serwer Cisco 7513 Series. Cisco 7513 Series 26 stron. Chassis replacement
Również dla Cisco 7513 Series: Skrócona instrukcja obsługi (44 strony), Arkusz danych (11 strony), Podręcznik (30 strony), Utrzymanie (20 strony), Instrukcja wymiany (19 strony), Instrukcja wymiany (22 strony)

Exchanging the EEPROM Devices

Figure 11

Captive screw

Card cage

side flange

Captive screw

Air intake grill

Step 6

Step 7

Caution

card cage and backplane assembly is removed from the chassis. To prevent damaging these

components, place the card cage and backplane assembly on an antistatic mat or foam, and place the

assembly in the same orientation as when it is mounted in the chassis. (See Figure 11.)

This completes the procedure for removing the old card cage and backplane assembly; proceed to

the next section, "Exchanging the EEPROM Devices."

Exchanging the EEPROM Devices

Before you install your new card cage, you must exchange the new EEPROM device(s) on the rear

of the new card cage for 00the old EEPROM device(s) on the rear of your old card cage. The

Cisco 7513 and Cisco 7513-MX include one EEPROM device and the Cisco 7576 includes two

EEPROM devices, one for router A and one for router B. The EEPROM device(s) on your old card

cage have MAC addresses programmed into them, which are necessary for your system to function

properly, and these old EEPROM device(s) are required for your system.

16 Cisco 7513, Cisco 7513-MX, and Cisco 7576 Card Cage and Backplane Assembly Replacement Instructions

Removing the Card Cage and Backplane Assembly

POW ER

With the captive screws loosened, carefully pull the card cage and backplane assembly

straight out of the chassis until the entire assembly is clear of the chassis sides. (See

Figure 11.) The assembly is not heavy but might be awkward to handle.

When the card cage and backplane assembly is completely free of the chassis, carefully

place it on an antistatic mat or foam.

The electronic components on the rear of the backplane are completely exposed when the

Captive screw

Card cage

side flange

Captive screw

POW ER