Cisco 7513 Series Instrukcja wymiany - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja wymiany dla Serwer Cisco 7513 Series. Cisco 7513 Series 26 stron. Chassis replacement
Również dla Cisco 7513 Series: Skrócona instrukcja obsługi (44 strony), Arkusz danych (11 strony), Podręcznik (30 strony), Utrzymanie (20 strony), Instrukcja wymiany (19 strony), Instrukcja wymiany (22 strony)

Drukuj stronę

Removing and Replacing Processor Modules

Before you can replace the card cage and backplane assembly, you need to remove all processor

modules installed in the card cage, and then replace them after the new card cage assembly is in

place. The term processor module refers to the RSP2, RSP4, or RSP8 and all interface processors.

Note

is partially seated in the backplane will cause the system to hang and subsequently crash.

Timesaver

interface cables, use the "Port and Slot Conﬁguration Worksheet" section on page 23 to note which

cables are connected to which interface processor ports.

Timesaver

processor modules and both power supplies. Plan this procedure so that you can minimize its effects

on your system.

Removing Processor Modules

To remove processor modules, follow these steps:

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Step 8

Cisco 7513, Cisco 7513-MX, and Cisco 7576 Card Cage and Backplane Assembly Replacement Instructions

Always use the ejector levers when installing or removing processor modules. A module that

To save time when you reinstall the processor modules in the card cage and reconnect

Before you can remove the card cage and backplane assembly, you must remove all

Turn off power to the chassis. If two power supplies are installed, the power switch on

each supply must be in the off (O) position.

Attach an ESD-preventive strap between you and an unpainted chassis surface.

If there is not enough slack in the network interface cables to remove the processor

module without straining the cables, disconnect any cables attached to the interface ports.

You must pull each processor module straight out of its slot. Ensure that there are no

obstructions that will prevent you from doing so, such as a power strip on a rack post,

network connection devices attached to adjacent processor modules, or extensive cabling

in front of the processor slots.

Use a screwdriver to loosen the captive installation screws at both ends of the processor

module. (See Figure 5a.)

Place your thumbs on the ejector levers on both ends of the processor module (see

Figure 5c) and simultaneously pull them both outward to release the processor module

from the backplane connector.

Grasp the processor module handle with one hand and place your other hand under the

carrier to support it. Pull the processor module straight out of the slot, keeping it at a

90-degree orientation to the backplane. (See Figure 7 on page 12.)

Place the removed processor modules in the black cardboard racks that were provided

with the original equipment packaging. (See Figure 6.) You can place all 13 processor

modules in these holders.

Removing and Replacing Processor Modules