Cisco APIC L4 Instrukcja instalacji i obsługi - Strona 30

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Serwer Cisco APIC L4. Cisco APIC L4 46 stron.

Initial Server Setup

Figure 12: Reversing the CMA

CMA tab on end of width-adjustment slider

Initial Server Setup

Note

Server Default Settings

The server is shipped with these default settings:

• The NIC mode is Dedicated (the only supported option in APIC).

• The NIC redundancy is None for Dedicated NIC mode.

• DHCP is enabled.

• IPv4 is enabled.

Connection Methods

There are two methods for connecting to the system for initial setup:

• Local setup—Use this procedure if you want to connect a keyboard and monitor directly to the system

Cisco APIC M4/L4 Server Installation and Service Guide

This section describes how to power on the server, assign an IP address, and connect to server management

when using the server in standalone mode.

for setup. This procedure can use a KVM cable (Cisco PID N20-BKVM) or the ports on the rear of the

server.

Metal button on outside of tab

Installing the Server