Epson ActionLaser 1500 Instrukcja konfiguracji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja konfiguracji dla Skaner Epson ActionLaser 1500. Epson ActionLaser 1500 18 stron. Imaging cartridge replacement procedure
Również dla Epson ActionLaser 1500: Papier i dostawa papieru (11 strony), Instrukcja instalacji (7 strony), Biuletyn wsparcia produktu (8 strony), Specyfikacja produktu (1 strony)

Connecting the printer to the

computer

You can connect up to three computers (two for the

ActionLaser 1000) to your printer at the same time. If you are

connecting more than one computer, see "Sharing Your

Printer" in the Reference Guide. To connect a parallel (factory

setting), serial (built-in on the ActionLaser 1500 only), or

optional interface, follow these steps. For information on

optional interface boards, see Chapter 5 in the Reference Guide.

1. Make sure both the printer and the computer are off.

2. Connect a properly shielded interface cable to the

appropriate interface connector. Parallel cables should be

the twisted-pair type.

3. Plug the other end of the cable into your computer.

4. Insert the interface cable into the u-shaped part of one cable

clip. Lift the left side of the printer up slightly. Then hook

the short lip of the clip into the forward slot and push the

bottom of the clip under the printer until it clicks in place.

Repeat this procedure with the second clip and insert it into

the back slot.

6 S e t u p