Cisco Nexus 7000 Series Instrukcja instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Serwer Cisco Nexus 7000 Series. Cisco Nexus 7000 Series 39 stron. Switch chassis
Również dla Cisco Nexus 7000 Series: Podręcznik referencyjny (2 strony), Odniesienie (34 strony), Instrukcja instalacji (18 strony), Konfigurowanie (8 strony), Podręcznik konfiguracji (28 strony), Skrócona instrukcja obsługi (10 strony), Skrócona instrukcja obsługi (29 strony), Instrukcja wymiany (14 strony), Instrukcja wymiany (21 strony), Instrukcja instalacji (16 strony), Instrukcja rozwiązywania problemów (10 strony)

Rack-Mount Kit Overview

Figure 2 shows the components in this mounting kit.

Figure 2

Bracket

Each of the chassis ears attaches to a side of the chassis with two M4 x 10-mm, Phillips, ﬂat-head

screws). When the chassis is in the rack, the mounting strips on the chassis ears attach to the

rack-mounting posts with four 10-32 x 5/8-inch, Phillips, pan-head screws. The ledges at the bottom

of the brackets support the weight of the chassis. The ears are not weight-bearing ﬁxtures, but

prevent the chassis from sliding out of the rack horizontally.

You can attach the ears to either the front or back of the chassis, whichever end you will place at the

most accessible end of the rack. For most installations, we recommend that you attach the ears to the

interface processor end (rear) so that you can have access to the power supplies, processor slots, and

all status LEDs.

4 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions

Rack-Mount Kit Components

M4 x 10-mm long Phillips

flat-head screws (to attach

ears to chassis)

10-32 x 5/8-inch long Phillips

pan-head screws with integral

square cone washers

(for mounting brackets and

chassis ears to rack posts)

Chassis ear with

captive sliding

grommets