B2 Mono Quattro Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz B2 Mono Quattro. B2 Mono Quattro 10 stron. High performance amplifiers

Drukuj stronę

4-4. SPEAKER CONNECTION

B2
amplifier series recommends 12 AWG speaker connecting cables.
Run 12 AWG speaker connecting cables from your speakers to amplifiers' mounting location
Keep speaker cables away from power cables and
Use grommets anywhere the cables have to pass through the holes in the metal frame or sheet
metal. Connect to the speakers according to terminals on each speaker.
Strip 3/8" of insulation from the end of each cable and twist the cables strands together tightly.
Make sure there are no stray strands that might touch other cables or terminals and cause a short circuit.
Crimp spade lugs over the cable ends or tin the ends with solder to provide a secure termination.
Connect the cable ends to
Mono
SPEAKER CONNECTION DIAGRAM i
CAUTION
Mono
minimum impedance is 1 ohm.
or
Mono
Linked minimum impedance is 2 ohm
Mono
SPEAKER CONNECTION DIAGRAM ii
B2
series amplifiers as shown on the speaker system diagram.
B2
series amplifier's input cables.
8 ohm ~
2ohms
8 ohm
~ 1ohms
8 ohm
~ 2ohms
5