B2 Audio RAGE 600.4 Podręcznik - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik dla Wzmacniacz B2 Audio RAGE 600.4. B2 Audio RAGE 600.4 16 stron.

Drukuj stronę
B2 Audio RAGE 600.4 Podręcznik
Panel layout
rage1200.6
INPUT CH1~CH6
RCA signal input for left & right on channel speci ed.
A minimum of 0.2V input signal is required for correct
operation.
rem
Connects to +12V switched remote from the headunit.
Push the tab to insert the wire and release after.
Gain (6v~0.2v) CH1/2
Adjusts signal input voltage from the input source
to match the ampli ers input stage. 0.2V ~ 6V is the
operational voltage. Voltages beyond may cause errors
or damage to the input section. All adjustments apply to
channel 1 & 2.
hpf
Adjusts the high pass crossover point to lter out audio
with a 24 dB slope from the given selection on ch 1 & 2.
The switch selection sets the HPF in active or fullrange.
If in HPF mode frequencies below the setting will be cut
with 24 dB per octave. Full setting is fullrange signal.
Full
No crossovers are applied.
lpf
Adjusts the low pass crossover point to lter out audio
with a 24 dB slope from the given selection on ch 1 & 2.
If in LPF mode frequencies above the setting will be cut
with 24 dB per octave. Full setting is fullrange signal.
Gain (6v~0.2v) CH3/4
Adjusts signal input voltage from the input source
to match the ampli ers input stage. 0.2V ~ 6V is the
operational voltage. Voltages beyond may cause errors
or damage to the input section. All adjustments apply to
channel 3 & 4.
hPF
See the description on the left side of the page.
Full
No crossovers are applied.
lpf
See the description on the left side of the page.
Gain (6v~0.2v) CH5/6
Adjusts signal input voltage from the input source
to match the ampli ers input stage. 0.2V ~ 6V is the
operational voltage. Voltages beyond may cause errors
or damage to the input section. All adjustments apply to
channel 5 & 6.
hPF
Adjusts the high pass crossover with 24 dB/oct at the set
frequency. Will works as a band pass if LPF switch is set
at 80 Hz or 250 Hz.
LPF switch
Sets up a band pass crossover on ch 5 & 6 if set at 80 Hz
(typically subwoofer applications) or 250 Hz for midbass
drivers. The band pass setting is dependant on the HPF
setting.
6