Cisco SFS 7008P Instrukcja instalacji i konfiguracji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji i konfiguracji dla Serwer Cisco SFS 7008P. Cisco SFS 7008P 34 stron. Infiniband server switch

Drukuj stronę
Cisco SFS 7008P Instrukcja instalacji i konfiguracji
Installing the Cisco SFS 7008P Switch into a Rack
Figure 8
4x copper
line interface
modules
Configuring and Connecting Host Channel Expansion Card for IBM BladeCenter
This section briefly describes configuring your InfiniBand host. Download the configuration software
and an integrated suite of drivers including IPoIB, SRP, SDP, uDAPL and MPI from the Cisco Software
Center at this URL:
http://www.cisco.com/public/sw-center
Install the Host Channel Expansion Card for IBM BladeCenter by doing the following:
Power down the host system following proper grounding procedures.
Step 1
Unpack the HCA module and insert it into an open 64-bit PCI or PCI-X slot.
Step 2
Power on the host system.
Step 3
Installing Host Channel Expansion Card Linux Drivers
Make sure your Linux kernel is supported. See www.cisco.com for a list of supported versions.
Cisco SFS 7008P InfiniBand Server Switch Installation and Configuration Note
10
Management I/O Modules Located in the Back of the Unit
Management I.O
modules
Power
plug
2
Chassis ID
Power
plug
1
Main air
exhaust
78-17434-01 Rev. A0