Cisco SFS 7008P Instrukcja instalacji i konfiguracji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji i konfiguracji dla Serwer Cisco SFS 7008P. Cisco SFS 7008P 34 stron. Infiniband server switch

•

Before You Install

Before you begin the installation, do the following:

•

Verifying Basic Hardware

If you have not purchased a fully loaded chassis with high-availability components installed, verify that

you have the minimum components necessary to run the chassis. Specific components in the Cisco SFS

7008P switch (see

Check for basic hardware by following these steps:

Verify that you have at least one management interface module installed in slot 15 at the back of the unit.

Step 1

(See

78-17434-01 Rev. A0

Three people to complete the installation (highly recommended). The Cisco SFS 7008P switch

chassis weighs up to 106 pounds fully loaded.

Make sure that you have the right cables and sufficient ventilation.

Open the Cisco SFS 7008P package and remove the chassis, rack brackets, parts bag, and

documentation from the box. Remove the packaging from around the chassis. After you have

removed the straps, lift the box up and away from the switch and pallet. Do not cut the packaging,

as you could damage the switch. Save the box and packaging.

Prepare a management workstation, such as a PC or laptop running a terminal program with a

rollover M/F DB-9 serial cable (included).

Figure 1

and

Figure

1.) Slot 15 is paired with the Fabric Controller in slot 11. (See

Cisco SFS 7008P InfiniBand Server Switch Installation and Configuration Note

Figure

2) have interdependencies on other components.

Before You Install

Figure

2.)