B2 Audio Zero.3 Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz samochodowy B2 Audio Zero.3. B2 Audio Zero.3 9 stron.
Drukuj stronę
2. Panel layout
Zero.3
INPUT
Signal input from the head unit. A minimum level
input of 0.2V is essential for correct operation.
POWER & PROTECTION INDICATOR
Power LED, Blue-lit shows correct operation.
Protect LED, Red-lit shows general malfunction,
faulty connection or thermal protection.
GAIN (6V ~ 0.2V)
Matching of the output voltage from the head unit's
RCA line-outs to the input section.
SUBSONIC FILTER (10Hz ~ 50Hz @ 24dB/Oct)
Adjusts the subsonic cut off point to eliminate
frequencies within the filter's range.
SPEAKER OUTPUTS
Amplifier connection to the loudspeakers.
Minimum speaker cable is 12 gauge.
Minimum impedance for the
used as a single unit.
In a daisy chain configuration the minimum
impedance is 2
.
BASS
BOOST
0dB 9dB
Zero.3
is 1
if
BASS
FREQ
30Hz
80Hz
SWEET LIKE DANISH
BASS BOOST
Variable bass boost with 0-9dB .
BASS FREQ
Variable bass boost frequency from 30Hz ~ 80Hz
LOW PASS FILTER (35Hz ~ 250Hz @ 24dB/Oct)
Adjusts the cut off point for the low pass filter
within the filter's range.
PHASE CONTROL
Variable phase adjustment from 0-180 degrees.
REMOTE LEVEL CONTROL PORT
Connection of external level control.
(The
Better Bass Remote
can be connected for additional features).
OUTPUT MASTER / INPUT SLAVE
For daisy chain connection of 2 Zero.3 amplifiers.
Minimum impedance is 2
Output signal can be routed from 1 master amplifier
to 2 slave amplifiers, by setting the switch to SLAVE1
& SLAVE2 on the amplifiers in question.
DO NOT USE IN DAISY CHAIN MODE!
4
MASTER
SLAVE1
SLAVE2
.