Cisco UCS B460 M4 Uwaga dotycząca instalacji i obsługi - Strona 34

Przeglądaj online lub pobierz pdf Uwaga dotycząca instalacji i obsługi dla Serwer Cisco UCS B460 M4. Cisco UCS B460 M4 50 stron. Blade server
Również dla Cisco UCS B460 M4: Arkusz danych (7 strony), Uwaga dotycząca instalacji i obsługi (46 strony), Skrócona instrukcja obsługi (2 strony), Skrócona instrukcja obsługi (5 strony)

Installing Memory

Figure 15: Thermal Grease Application Pattern

Step 10

Replace the heat sink. See callout 4.

Caution

Step 11

Secure the heat sink to the motherboard by tightening the four captive screws a quarter turn at a time in an X

pattern as shown in the upper right.

To install a DIMM into the blade server, follow these steps:

Procedure

Step 1

Press the DIMM into its slot evenly on both ends until it clicks into place.

DIMMs are keyed. If a gentle force is not sufficient, make sure the notch on the DIMM is correctly aligned.

Note

Step 2

Press the DIMM connector latches inward slightly to seat them fully.

The DIMMs supported in this blade server are constantly being updated. A list of currently supported and

available DIMMs is in the specification sheets at:

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v3 and E7 v2 CPUs

On certain models, heat sinks are keyed to fit into the plastic baffle extending from the motherboard.

Do not force a heat sink if it is not fitting well, rotate it and re-orient the heat sink.

Be sure that the notch in the DIMM aligns with the slot. If the notch is misaligned you may damage

the DIMM, the slot, or both.

Servicing the Blade Server