Cisco 1700 series Podręcznik konfiguracji - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik konfiguracji dla Gateway Cisco 1700 series. Cisco 1700 series 25 stron. Secure firewall management center
Również dla Cisco 1700 series: Podręcznik dotyczący zgodności z przepisami i informacji na temat bezpieczeństwa (45 strony), Podręcznik (15 strony), Nota aplikacyjna (41 strony), Rozwiązywanie problemów ze sprzętem (12 strony), Podręcznik przeglądowy (13 strony), Konfigurowanie (34 strony), Podręcznik (5 strony), Skrócona instrukcja obsługi (6 strony), Instrukcja instalacji sprzętu (46 strony)

IOS Commands

This section describes the full-duplex and half-duplex IOS commands. Cisco WIC-1ENET is set to

half-duplex mode by default, and it does not auto-sense. If you set the Cisco WIC-1ENET to full-duplex

operation, you must also set the device to which the port is attached to full-duplex mode.

full-duplex Command

To put the Ethernet interface into full-duplex mode, use the full-duplex command. The "no" form of this

command changes the port to half-duplex mode.

Syntax Description

full-duplex

no full-duplex

Default

Half-duplex mode

Command Mode

Interface configuration mode

Usage Guidelines

Use the full-duplex command to put the Cisco WIC-1ENET Ethernet interface into 10-Mbps full-duplex

operation. The interface can be put into half-duplex mode again by entering the no full-duplex

command.

Example

The following example puts the Cisco WIC-1ENET Ethernet interface into full-duplex mode:

1750(config)#interface Ethernet 0

1750(config-if)#full-duplex

The following example puts the Cisco WIC-1ENET Ethernet interface into half-duplex mode:

1750(config)#interface Ethernet 0

1750(config-if)#no full-duplex

To verify the interface state, enter a show interface command as follows:

1750#show interface Ethernet 0

Ethernet0 is up, line protocol is up

Hardware is PQUICC Ethernet, address is 0001.64ff.ef6a (bia 0001.64ff.ef6a)

MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Full-duplex, 10BaseT

....

78-11422-03

full-duplex

no full-duplex

Interface is in full-duplex mode.

Interface is in half-duplex mode.

reliability 255/255, txload 1/255, rxload 1/255

IOS Commands