Cisco 3G MicroCell Podręcznik użytkownika - Strona 19
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Gateway Cisco 3G MicroCell. Cisco 3G MicroCell 20 stron. At&t wireless network gps signal extender
Również dla Cisco 3G MicroCell: Podręcznik użytkownika (20 strony), Podręcznik użytkownika (20 strony), Skrócona instrukcja obsługi (8 strony)
Drukuj stronę
FCC Compliance
United States FCC Compliance
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against such interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy. If not installed and used in accordance with the instructions, it may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment OFF and ON, the user
is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna, if applicable.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the service provider or an experienced radio/television technician
for help.
Any changes or modifications not expressly approved by Cisco Systems, Inc.,
could void the user's authority to operate the equipment.
The information shown in the FCC Declaration of Conformity paragraph below
is a requirement of the FCC and is intended to supply you with information
regarding the FCC approval of this device. The phone numbers listed are for FCC-
related questions only and not intended for questions regarding the connection
or operation for this device. Please contact your service provider for any
questions you may have regarding the operation or installation of this device.
Declaration of Conformity
This device complies with Part 15 of FCC Rules. Operation is subject to the
following two conditions: 1) the device may not cause harmful interference,
and 2) the device must accept any interference received, including interference
that may cause undesired operation.
AT&T 3G MicroCell™
Model: MicroCell
Manufactured by: Cisco Systems, Inc.
5030 Sugarloaf Parkway
Lawrenceville, Georgia 30044 USA
Telephone: 770-236-1077
Canada EMI Regulation
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la class B est conforme à la norme NMB-003
du Canada.
This device complies with RSS-132 and RSS-133 of the Industry Canada Rules.
Operation is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference
that may cause undesired operation.
4030453_RevA_6.75x8.25_Mar6.indd 19
4030453_RevA_6.75x8.25_Mar6.indd 19
Software and Firmware Use
The software described in this document is protected by copyright law and
furnished to you under a license agreement. You may only use or copy this
software in accordance with the terms of your license agreement.
The firmware in this equipment is protected by copyright law. You may only
use the firmware in the equipment in which it is provided. Any reproduction or
distribution of this firmware, or any portion of it, without our express written
consent is prohibited.
Disclaimer
Cisco Systems, Inc. assumes no responsibility for errors or omissions that
may appear in this guide. We reserve the right to change this guide at any
time without notice.
Radiation Exposure Statements
Note: This transmitter must not be collocated or operated in conjunction
with any other antenna or transmitter. This equipment should be installed
and operated with a minimum distance of 7.9 inches (20 cm) between the
radiator and your body.
United States
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This system has been evaluated for RF exposure for
humans in reference to ANSI C 95.1 (American National Standards Institute)
limits. The evaluation was based on evaluation per ANI C 95.1 and FCC OET
Bulletin 65C rev 01.01. The minimum separation distance from the antenna/
radiator to a general bystander is 7.9 inches (20 cm) to maintain compliance.
This transmitter must not be collocated or operating in conjunction with any
other antenna or transmitter.
The availability of some specific channels and/or operational frequency
bands are country dependent and are firmware programmed at the factory
to match the intended destination. The firmware setting is not accessible
by the end user.
Canada
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This system has been evaluated for RF exposure
for humans in reference to ANSI C 95.1 limits. The evaluation was based on
evaluation per RSS-102 Rev 2. The minimum separation distance from the
antenna to general bystander is 7.9 inches (20 cm) to maintain compliance.
20060628 FCC Standard
19
3/6/2009 5:43:35 PM
3/6/2009 5:43:35 PM