Cisco ASR 9000 Series Podręcznik konfiguracji - Strona 23
Przeglądaj online lub pobierz pdf Podręcznik konfiguracji dla Gateway Cisco ASR 9000 Series. Cisco ASR 9000 Series 50 stron. Line card
Również dla Cisco ASR 9000 Series: Konfigurowanie ustawień sieciowych (26 strony), Podręcznik konfiguracji (46 strony), Podręcznik (24 strony), Konfigurowanie (46 strony), Podręcznik (44 strony), Skrócona instrukcja obsługi (7 strony)
Drukuj stronę
Configuring Serial Interfaces on the Cisco ASR 9000 Series Router
•
•
Creating a Point-to-Point Serial Subinterface with a PVC
The procedure in this section creates a point-to-point serial subinterface and configures a permanent
virtual circuit (PVC) on that serial subinterface.
Subinterface and PVC creation is supported on interfaces with Frame Relay encapsulation only.
Note
Prerequisites
Before you can create a subinterface on a serial interface, you must bring up the main serial interface
with Frame Relay encapsulation, as described in the
page
Restrictions
Only one PVC can be configured for each point-to-point serial subinterface.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
OL-26061-03
To modify the default keepalive configuration, see the
Interfaces" section on page
To modify the default Frame Relay configuration on serial interfaces that have Frame Relay
encapsulation enabled, see the
section of the
"Configuring Frame Relay on the Cisco ASR 9000 Series Router"
514.
configure
interface serial interface-path-id.subinterface point-to-point
ipv4 address ipv4_address/prefix
pvc dlci
end
or
commit
Repeat Step 1 through Step 5 to bring up the serial subinterface and any associated PVC at the other
end of the connection.
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
526.
"Modifying the Default Frame Relay Configuration on an Interface"
"Bringing Up a Serial Interface" section on
How to Configure Serial Interfaces
"Modifying the Keepalive Interval on Serial
module.
521