Cisco ISDN GW 3241 Podręcznik użytkownika - Strona 9

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Gateway Cisco ISDN GW 3241. Cisco ISDN GW 3241 15 stron. High performance video gateway which enables isdn network connectivity for cisco telepresence ip
Również dla Cisco ISDN GW 3241: Pierwsze kroki (17 strony)

Drukuj stronę

To configure Ethernet Port A, enter the following for auto-sensing mode:

ethertype A auto

or to configure a speed and duplex, use the following command:

ethertype A <10|100> <half|full>

To display the current configuration and status of the Ethernet ports, enter:

status

For example, to configure a full-duplex 100 Mbps link, enter:

ethertype A 100 full

To establish a 1000 Mbps connection, both ends of the link must be

configured as auto-sensing.

Step three: Assign an IP address to the ISDN GW 3241

(optional)

The default setting for the ISDN GW 3241 is to use DHCP to obtain an IP address.

You can assign a static IP address if you prefer or if a DHCP server is not available. If

you want the IP address to be assigned by your DHCP server, omit this step.

From Version 2.1, ISDN GW 3241 software supports IPv4 and IPv6

addressing. By default, Port A is configured to assign an IPv4 address

using DHCP and IPv6 on Port A is disabled.

From Version 2.1:

To assign a static IPv4 address to Port A, use the following command:



static A <IP address> <netmask> [<default gateway address>]

For example, to assign an address of 192.168.1.2 where the default gateway is at

192.168.1.1, enter:

static A 192.168.1.2 255.255.255.0 192.168.1.1

To set DNS manually, use this command:



dns <DNS server address> [<secondary DNS server>][<domain>]

To return to using DHCP after setting a static IPv4 address, use the following



command:

dhcp -4 A

Initial configuration