Cisco Meraki Z3C Instrukcja instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Gateway Cisco Meraki Z3C. Cisco Meraki Z3C 6 stron.
Również dla Cisco Meraki Z3C: Instrukcja instalacji (10 strony)

Drukuj stronę

Mounting Hardware

The supplied wall screws and anchors allow you to mount the gateway on a drywall surface, either vertically or horizontally.

• For mounting on drywall, use a ¼-in drill bit, then insert the plastic and screw assemblies.

• For mounting on wood or a similar surface, use only the screws.

• Allow the heads of the screws to stick out far enough to be inserted securely into the back of the gateway.

Connecting to WAN

All Meraki Z3C devices must have an IP address. This section describes how to configure your local area network before you deploy it. A local management web

service, running on the gateway, is accessed through a browser running on a client PC. This web service is used for configuring and monitoring basic ISP/WAN

connectivity.

Setting up a Static IP Address

Note: To ensure that the client PC is redirected to the local web service in the following step, you must disable all other network services (ex: Wi-Fi)

on your client machine.

Do the following to configure basic connectivity and other networking parameters:

1. Using a client machine such as a laptop, connect to one of the four LAN ports of the Z3C.

2. Using a browser on the client machine, access the gateway's built-in web service by browsing to

http://setup.meraki.com. (You do not have to be connected to the Internet to reach this address)

3. Click Uplink configuration under the Local status tab. The default credentials use the device serial number as

the username, with a blank password field.

4. Choose Static for the IP Assignment option.

5. Enter the IP address, subnet mask, default gateway IP and DNS server information.

Setting up a DHCP IP Address

By default all Z3C devices are configured to DHCP from upstream WAN / ISP servers. Simply plug the Z3C's WAN / Internet port to your upstream circuit and

wait a few minutes for the unit to negotiate a DHCP address. If your Z3C device was configured to have a static address (and not attempt to negotiate DHCP),

you can held the reset button while the device is powered until the lights on the device turn off. Doing so will return the Z3C device to its default DHCP settings.

Note: When the WAN connection is fully enabled, the device's front LED will be solid white.

Setting up Cellular Failover

The Z3C has an embedded LTE module for cellular failover connections. The following section will walk through first-time set-up of a Z3C with an internet

connection as a primary connection and cellular as failover.