Cisco RF Gateway 10 Skrócona instrukcja obsługi - Strona 31
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Gateway Cisco RF Gateway 10. Cisco RF Gateway 10 41 stron. Cisco systems rf gateway quick start guide
Drukuj stronęConfigure System Management? [yes/no]: no
If you want to access the router using SNMP, enter Yes at the prompt:
Step 8
Configure SNMP Network Management? [yes]: yes
Specify an SNMP community string.
Step 9
Community string [public]: public
Using Configuration Mode to Configure Your Switch
To configure your switch from configuration mode, use the following procedure:
Connect a console terminal to the console interface of your supervisor card.
Step 1
After a few seconds, you will see the user EXEC prompt (
Step 2
also known as enable mode. Type enable to enter enable mode:
Switch> enable
You must be in enable mode to make configuration changes.
Note
The prompt will change to the enable prompt (#):
Switch#
Step 3
At the enable prompt (#), enter the configure terminal command to enter global configuration mode:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#
At the global configuration mode prompt, enter the interface type slot/interface command to enter interface
Step 4
configuration mode:
Switch(config)# interface fastethernet 5/1
Switch(config-if)#
Step 5
In either of these configuration modes, enter changes to the switch configuration.
Step 6
Enter the end command to exit configuration mode.
Save your settings.
Step 7
Your switch is now minimally configured and can boot with the configuration you entered. To see a list of the configuration
commands, enter '?' at the prompt or press the help key in configuration mode.
Configuring a Default Gateway
Note
The switch uses the default gateway only when it is not configured with a routing protocol.
Configure a default gateway to send data to subnets other than its own when the switch is not configured with a routing
protocol. The default gateway must be the IP address of an interface on a router that is directly connected to the switch.
To configure a default gateway, perform this procedure:
Configure a default gateway.
Step 1
Switch(config)# ip default-gateway IP-address
Step 2
Verify that the default gateway is correctly displayed in the IP routing table.
Switch# show ip route
This example shows how to configure a default gateway and how to verify the configuration:
Switch# configure terminal
Enter configuration commands, one per line.
). Now, you may want to enter privileged EXEC mode,
Switch>
End with CNTL/Z.
31