Epson Stylus CX3800 Series Podręcznik użytkownika - Strona 8
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Skaner Epson Stylus CX3800 Series. Epson Stylus CX3800 Series 9 stron. Epson scan icm updater v1.20 (psb.2008.07.001)
Również dla Epson Stylus CX3800 Series: Skrócona instrukcja obsługi (36 strony), Streszczenie techniczne (6 strony), Podręcznik Start Here (8 strony), Aktualizacja (1 strony)
Epson Stylus CX3800 Series
5. Open the cartridge cover and squeeze the tab at the back of
the empty/low cartridge and lift it straight out. Dispose of it
carefully. Do not take the used cartridge apart or try to refill
it.
WARNING:
If ink gets on your hands, wash them thoroughly with soap and
water. If ink gets into your eyes, flush them immediately with
water.
6. Before you open the new ink cartridge package, shake it
four or five times. Then remove it from the package.
Caution:
Do not remove or tear the label on the
cartridge; otherwise, ink will leak.
Do not touch the green chip on the side of
the cartridge. This can damage the ink
cartridge.
7. Place the new ink cartridge into the cartridge holder and
push it down until it clicks into place.
8. Replace any other cartridges that need to be replaced.
Epson Stylus CX3800 Series
8 -
9. Close the ink cartridge cover and press it until it clicks into
place.
10. Close the scanner.
B
11. Press the
ink button. The Epson Stylus CX begins
charging ink and the P
about one minute. When it's finished, the P
flashing and remains on, and the
Caution:
Never turn off the Epson Stylus CX while the P On light is
flashing or you'll waste ink.
Note:
B
If the
ink light stays on (not flashing), the ink cartridge may not
be installed correctly. Press the
the ink cartridge until it clicks into place.
Related Documentation
CPD-18248
Epson Stylus CX3800 Series Start Here
CPD-18250
Epson Stylus CX3800 Series Quick Guide
CPD-18247
Epson Stylus CX3800 Series CD-ROM
(includes on-screen User's Guide)
6/05
light starts flashing. This takes
On
light stops
On
B
ink light goes out.
B
ink button again and reinstall