Epson Stylus Photo RX600 Instrukcja konfiguracji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja konfiguracji dla Skaner Epson Stylus Photo RX600. Epson Stylus Photo RX600 2 stron. Product support bulletin(s)
Również dla Epson Stylus Photo RX600: Wskazówki (2 strony), Karta informacyjna produktu (4 strony), Informacje o produkcie (19 strony), Broszura (2 strony), Podręcznik Start Here (10 strony), Skrócona instrukcja obsługi (28 strony), Podręcznik użytkownika (12 strony), Aktualizacja (1 strony), Biuletyn wsparcia produktu (6 strony), Biuletyn wsparcia produktu (1 strony), Specyfikacje (2 strony), Jak kopiować i drukować (20 strony), Instrukcja obsługi (4 strony)

Drukuj stronę

Epson Stylus Photo RX600 Instrukcja konfiguracji

For EPSON STYLUS PHOTO RX500/600 and EPSON STYLUS CX4600/

6400/6600 Users (Windows Users Only)

Follow the steps below to set up the all-in-one for use on a

wireless network.

Make sure the all-in-one is set up and the software for the all-in-

one is installed on your computer before taking the steps below.

See the manual shipped with the all-in-one for detailed

instructions.

Note:

If EpsonNet WinAssist is installed on your computer, uninstall it

before following the steps below.

It is a good idea to write down the SSID and WEP Key or WPA

Personal password before taking the steps below.

Windows Server 2003 is not supported.

1. Insert the Software CD-ROM in the CD-ROM drive.

2. From the Welcome screen, click Next.

3. Read the license agreement, and then click Agree.

4. Select Connect the Wireless Print Server.

5. Connect the network interface and the all-in-one with a USB

cable. Finally, turn on the all-in-one.

Note:

Be sure to use the USB cable that comes with the network

interface. If the all-in-one has a built-in USB cable, use it to connect

to the network interface.

6. Connect the square connector on the USB cable to the USB

upstream connector on the network interface, and then

connect the other end to the USB port on the computer.

7. Connect the power cord to the AC adapter, and then plug

the AC adapter into the network interface's DC-IN

connector. Finally, plug the power cord into a properly

grounded wall outlet.

8. The "Found New Hardware Wizard" appears to prompt you

to install the USB driver. Select the Install from a list or specific

location radio button and then click Next.

Note for Windows XP Service Pack 2 Users:

If the following screen appears, select the No, not this time radio

button, and then click Next.

Select the Search for the best driver in these locations radio button

and then select the Search removable media check box. Finally,

click Next.

When the operation is completed, click Finish.

Note:

These screens may be different depending on the operating

system.

9. Click Next.

10. Select the model of the all-in-one.

11. Click Install. Follow the on-screen instructions to make the

wireless settings and TCP/IP settings and install the drivers.

Note for Windows XP Service Pack 2 users:

If the following screens appear, click the Unblock button.

12. Pull out the USB cable from your computer and the network

interface.

13. Now you can use the all-in-one on the wireless network.

Printed in XXXXXX XX.XX-XX