Epson Stylus Scan 2500 Instrukcja konfiguracji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja konfiguracji dla Skaner Epson Stylus Scan 2500. Epson Stylus Scan 2500 35 stron. Epson imaging products (scanners, digital cameras, and stylus scan devices) compatibility chart for macintosh os x classic
Również dla Epson Stylus Scan 2500: Podręcznik użytkownika (7 strony), Karta informacyjna produktu (4 strony), Specyfikacje (2 strony), Karta informacyjna produktu (4 strony), Biuletyn wsparcia produktu (12 strony), Informacje o produkcie (12 strony), Zacznij tutaj (4 strony), Podręcznik (11 strony), Biuletyn wsparcia produktu (3 strony), Lista części (9 strony), Podręcznik online (10 strony), Zacznij tutaj (4 strony), Informacje uzupełniające (12 strony)

Connecting the Stylus Scan to Your Computer

Your Stylus Scan has two ports through which it can be connected to a computer; a

parallel port and a USB port. Use the port appropriate for your computer.

Note:Note:

If your computer has both a parallel and USB port, be sure to follow the correct

steps for connecting to the port you choose.

Do not use the Stylus Scan's parallel port and USB port simultaneously.

Connect the Stylus Scan to one computer at a time.

Using the parallel port (for Windows 95 or 98)

To connect the Stylus Scan to your PC using the parallel port, you need a shielded,

twisted-pair parallel cable. Follow these steps.

Make sure both the Stylus Scan and computer are turned off.

Plug the cable connector securely into the parallel interface connector at the rear

of the Stylus Scan. Then squeeze the wire clips together until they lock in place

on both sides. If there is a ground wire at the end of the cable, connect it to the

ground connector at the back of the Stylus Scan.

Plug the other end of the cable into the computer's parallel interface.

You are now ready to install the Stylus Scan drivers. For installation instructions, see

"For Windows 95 or 98 with a parallel connection" auf Seite -11.

Using the USB port (for Windows 98 or Macintosh)

To connect the Stylus Scan to your computer using the USB port, you must first install

the Stylus Scan drivers.

See "For Windows 98 with a USB connection" auf Seite -14 to install the drivers and

connect the Stylus Scan to your Windows 98 computer using the USB port.

To install the software and connect the Stylus Scan to your Macintosh, see "Installing

the Software in Your Macintosh" auf Seite -21.

Turn the Stylus Scan on by pressing the

Press the Quality and B&W/Color button at the same time to enter the Menu

Mode.

power button.

Setting up your Stylus Scan 2500