DIGIWAY PTY SW50-2 Instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Silnik DIGIWAY PTY SW50-2. DIGIWAY PTY SW50-2 16 stron. Dual swing gate motor
Drukuj stronę
1. General Descriptions and features
General descriptions
1.1
It is recommended reading and understanding this manual before start to install the control board.
Some features and idea are new. So, take some time to read through the manual to get better
understanding of the board. That will save your time during installation and get the best benefit
from the control board.
1.2 General features
SW50 is designed for most of domestic swing gate. It can be mounted on brick wall/pier or steel
post. The arm supplied can be met most of application situations. If special need, customer can
modify arm or ask supplier/dealer to contact manufacturer for different arm.
Before installation must check:
A) Gate moves freely by hand without any difficulty in either open and closing directions.
B) The post or pier must be strong enough.
C) Gate must have open and closed stopper
D) 240V 10A power point must be available within one metre of the post/pier
E) If there is not enough side room, minimum side room requirement see following drawing.
2. Motor installation
Two arms are the exactly same. For different gate or different application, can cut the arm to the
required length to suit the gate.
MAIN FEATURES
- 3 -