Epson FX-1180 - Impact Printer Informacje o produkcie - Strona 12

Przeglądaj online lub pobierz pdf Informacje o produkcie dla Akcesoria do drukarek Epson FX-1180 - Impact Printer. Epson FX-1180 - Impact Printer 17 stron. Epson serial impact dot matrix printers
Również dla Epson FX-1180 - Impact Printer: Instrukcja konfiguracji (33 strony), Broszura i specyfikacje (24 strony), Skrócona instrukcja obsługi (16 strony), Podręcznik (11 strony), Specyfikacja (2 strony), Podręcznik (18 strony), Specyfikacje (2 strony), Ograniczona gwarancja (1 strony), Podręcznik referencyjny (34 strony), Skrócona instrukcja obsługi (33 strony)

Drukuj stronę

Epson FX-1180 - Impact Printer Informacje o produkcie

EPSON FX-880/FX-1180

Note:

Your tear-off position setting remains in effect until you change it,

even if you turn off the printer.

1. Make sure the

Tear Off/Bin

the current tear-off position). You may need to press the

button.

Tear Off/Bin

2. Hold down the

Pause

light begins flashing and the printer enters the micro

Pause

adjust mode.

3. Press the

Load/Eject U

paper backward or forward until the paper perforation is

aligned with the tear-off edge of the printer cover.

Note:

The printer has a minimum and a maximum tear-off position. If

you try to adjust the tear-off position beyond these limits, the

printer beeps and stops moving the paper.

4. Press the

button to turn off micro adjust mode.

Pause

Then tear off the printed pages.

When you resume printing, the printer automatically feeds the

paper back to the top-of-form position and begins printing.

Replacing the Ribbon Cartridge

Warning:

You need to move the print head by hand to install or

replace the ribbon cartridge. If you just used the

printer, the print head may be hot; let it cool before

you replace the ribbon cartridge.

Caution:

Make sure the printer is off and unplugged from the

electrical outlet. Moving the print head while the

printer is on may damage the printer.

1. Remove the printer cover.

12 - EPSON FX-880/FX-1180

light is flashing (the paper is at

button for about three seconds. The

and

buttons to feed the

LF/FF D

tear-off edge

2. Press up the tabs on the paper tension unit, then lift the

front of the unit and pull it up and out of the printer.

paper tension unit

3. Make sure that the print head is not hot; then slide the print

head to the middle of the printer by hand.

ribbon cartridge handle

4. Grasp the used ribbon cartridge by its handle and pull it up

and out of the printer.

5. Turn the ribbon-tightening knob of the new ribbon

cartridge in the direction of the arrow to remove any slack

in the ribbon.

11/98

print head