DIGWDF ESP/XBee Snap-In Podręcznik użytkownika - Strona 3
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Adapter DIGWDF ESP/XBee Snap-In. DIGWDF ESP/XBee Snap-In 9 stron. Wireless adapter board
Drukuj stronęRenard-Plus (and other) installations
With XBee radio
Required parts are
highlighted in
BLUE. Install the
female 5-pin
header on the
BOTTOM of the
PCB for plug-in
convenience to any
RP controller. For
other controllers,
install the 5-pin
male header on the
TOP and use
connection cables
to connect to your
controller:
Pin 1 = +5v
Pin 3 = GND
Pin 5 = Data
Snap-In as a Transmitter/XBee Programmer
If you plan to use the Snap-In with your computer as an XBee transmitter,
install the parts as noted in blue to the right: It's suggested to install the
male 5-pin header in the upper-right corner of the PCB to make it easy to
connect it to your computer using an USB-TTL adapter as follows:
Pin 1 = +5v
Pin 3 = GND
Pin 4 = TX data from the USB-TTL adapter
Install a jumper shunt on the 2-pin XMIT header.
The transmitter mode only applies to using an XBee radio and not an ESP-01
module.
XBee Programmer: connect the Snap-In pin 5 (of the 5-pin header) to the
RX line of the USB-TTL adapter for duplex communication to the XBee radio
and use your XBee's XCTU software to connect to the USB-TTL adapter and
change the settings in your XBee radios.
DIGWDF XBee/ESP Snap-In Assembly & User Guide – v 20170308 -Page 3
With ESP-01
module
Required parts are
highlighted in BLUE.
Install the female 5-
pin header on the
BOTTOM of the PCB
for plug-in
convenience to any RP
controller. For other
controllers, install the
5-pin male header on
the TOP and use
connection cables to
connect to your
controller:
Pin 1 = +5v
Pin 3 = GND
Pin 5 = Data
Note: a 100uf cap is
suggested in place of
.1uf . Also remember
to solder the proper
TX/2/0 circuit for
your version of the
ESP firmware.