TomTom Eclipse AVN2210p Instrukcja obsługi - Strona 13
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla GPS TomTom Eclipse AVN2210p. TomTom Eclipse AVN2210p 44 stron. In-dash portable navigation with cd/usb multi-source receiver
![TomTom Eclipse AVN2210p Instrukcja obsługi](/uploads/products/server2/6003317/6003317.jpg)
Memorizing Stations Automatically
1
Press the [FUNC] button to establish the FUNCTION mode.
2
Press the [FUNC] button until the sub display switches to ASM.
3
Press the [ENTER] button.
After "ASM ON" is displayed, automatic station selection will start. A search will be
conducted from the lowest frequency through progressively higher frequencies and
stations with strong reception will be memorized for preset registration numbers [1] to
[6].
When the operation has ended the "ASM ON" indication will be cleared and the station
memorized last (i.e. the one memorized for P6) will continue to be received.
Subsequently, when you listen to the radio you will be able to select stations by calling
up preset numbers.
ATTENTION
• Pressing the preset switches ([1] to [6]) allows you to make one-touch station selections. The
frequency of the selected station is displayed on the preset switch.
• When a new station is set in memory, the station previously set in memory will be deleted.
• If there are fewer than six receivable stations, the stations set in the remaining switches will
remain unchanged.
CAUTION
If the vehicle's battery is disconnected (for repairs to the vehicle or for removing the main unit), all
stations in memory will be lost. In such a case, set stations in memory again.
Preset Station Scan
This function enables reception of all the stations in the preset switches to be played for five seconds
each.
1
Press the [FUNC] button to establish the FUNCTION mode.
2
Press the [FUNC] button until the sub display switches to P SCAN.
3
Press the [ENTER] button.
"P SCAN" will be displayed and the stations memorized for preset channels P1 to P6
will be called up in order and received for five seconds each.
To cancel the preset scan, press the [FUNC] button.