Argos Home 430/6298 Instrukcja montażu - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Oświetlenie zewnętrzne Argos Home 430/6298. Argos Home 430/6298 3 stron. Black outdoor lantern
Drukuj stronęAssembly Instructions
Stage 1 –
Fitting the Decoration Glass
NOTE: Ensure electricity is
switched off at the mains before
installing or maintaining any
light fixture.
NOTE: Glass is very fragile. Handle
it carefully and keep away from
children.
1. Locate the Decoration Glasses F
onto the Base A . Then place the
Plastic Plugs
G
onto the small
tubes located at the bottom of the
Base A .
See fig. 1.
NOTE: Ensure Decoration Glasses
face out and locate in place .
NOTE: Make sure the Plastic Plugs
are firmly located on Base, as
these fix the Decoration Glass
in place.
2. Locate the Brackets
J
onto the
top of the Base A . Use the Short
Screws
C
to fix the Decoration
Glasses F into the Base.
See fig. 2.
Stage 2 –
Wall Mounting
IMPORTANT: When drilling into
walls always check that there
are no hidden wires or pipes etc.
Make sure that the screws and
wall plugs supplied are suitable
for supporting the unit. Consult
a qualified tradesperson if you
are not sure.
F
fig. 1
A
C
J
J
A
Assembly Instructions
Stage 2 –
Wall Mounting
NOTE: It would be useful to ask
someone to help you at this
stage.
WALL MOUNTING: Hold the unit
against the wall in the desired
location and check if its
horizontal. Mark the wall to
indicate where to drill the holes
then drill using an appropriately
F
sized drill bit.
1. Cut a small circle into the rubber
plug located on the Mounting Plate
D , smaller than the diameter of
the electric cable, this will act as
a water ingress guard.
See fig. 3.
G
2. Insert the Mounting Screws
thread the mains cable through the
back of the Mounting Plate D and
the Rubber Plug.
See fig. 3.
3. Position the Mounting Plate D in
the desired location and screw into
place using Long Screws A. Locate
the Ring E onto Screws
See fig. 3 and 5 .
4 Use Terminal Block
the mains supply, ensure all the
wires are firmly fixed in place.
See fig. 4 and 5.
CAUTION - Carefully wire the light
fig. 2
to the mains and turn on to
check the function of the lamp
is working
5. Use Nuts
I
to fix the Base A and
Ring E into place
See fig. 5.
A
F
and
MAINS
BROWN
BLUE
GREEN
YELLOW
F
.
E
to connect
A
fig. 3
B
D
F
B
LIGHT
LIVE
NEUTRAL
EARTH
E
fig. 4
E
D
E
F
I
fig. 5