Dill 1504-572 Podręcznik - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik dla Akcesoria samochodowe Dill 1504-572. Dill 1504-572 12 stron. Tpms trailer kit

An immediate audible

minutes, the display unit will show the tire pressures in yellow, along with four

blue tire position lights.

3.2 Transmitter Activation

Note: reference section 2 for transmitter installation.

The transmitters are shipped in "sleep" mode for battery conservation and will

be activated when the transmitter detects pressure in the tires or when the vehi-

cle speed exceeds 20mph.

The default cold inflation pressure setting of the display unit is 35PSI.

play unit is programmed to provide a low pressure warning when the pressure is

20% lower (28PSI) and 30% higher (46PSI).

Cold inflation pressure can be set to your desired pressure and a warning will

alarm at 20% below and 30% above this pressure. For example, the driver will

be alerted at the following low and high pressures base on various set pressure:

PSI LEVEL

Cold inflation pressure setting is pre-set at the to 35PSI, when installation and

replacement of each transmitter and ID modules.

To change cold inflation pressure setting, perform the following:

3.3.1 Inflate the tire pressures to the recommended cold inflation pressure.

3.3.2 Press the "SET" key on the back of display and hold for 8 seconds to

enter new cold inflation pressure setting. A „beep‟ will sound and all

indicator lights will turn off and the screen display will show "ddd". Al-

low 3 to 5 minutes for the receiver to accept new cold inflation pres-

sure setting.

3.3.3 To check a tire‟s cold inflation pressure setting, press and release the

"Cycle Button" twice. Repeating this step will cycle through each

tire‟s pressure setting.

To switch to default setting, press and hold the "RESTORE" key for 3 seconds.

The display unit will switch back to default operations within 30 seconds.

"Beep" sound will indicate the display unit is on. In 2 to 3

20% LOWER 30% HIGHER

The dis-

104