Dillon Quantrol BFG 2500 Podręcznik użytkownika - Strona 11
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Przyrządy pomiarowe Dillon Quantrol BFG 2500. Dillon Quantrol BFG 2500 17 stron. Basic force gauge
Drukuj stronę
Data Output
BFG uses 9600 Baud
8 data bits, 1 start bit
1 stop bit and no
parity.
A full range of data
cables are available to
connect your gauge to
peripheral devices –
contact your supplier.
Optional Settings
Backlit Display
Auto-off
10
Press the RESET key to clear both maximum
registers and prepare for detecting the next
maximum readings.
The BFG has RS-232, Mitutoyo and analog
output signals. It is possible to transmit the
displayed reading to peripheral devices (e.g. PC,
printer) by pressing and releasing the TXD key.
Displayed readings can also be requested
individually from a PC via the RS-232 interface by
sending a"?" (ascii D63 [3fh] character.
For sending a continuous data stream to a PC,
press and hold the TXD key for 2 seconds then
release. TX will now appear in the display to
indicate that data is being sent. To stop sending
data, simply press and release the TXD key, at
which point TX will disappear from the display.
Please note that the continuous data stream only
starts when approximately 2% of the rated
capacity of the gauge is reached.
It is possible to activate a backlight on the BFG
display.
Press and hold RESET while powering up the
BFG with the ON/OFF key. The backlight is now
operating. The backlight will go out when the unit
is powered off. Repeat the process to turn the
backlight back on.
Please note that battery consumption is doubled
when using the backlight.
To conserve battery power, you can activate an
Auto-off function so that the gauge powers down
two minutes after the last key press.
Press and hold ZERO while powering up the BFG
with the ON/OFF key. The symbol Ao will appear
in the display to indicate Auto-off is active.
Basic Force Gauge User's Manual