AEMC instruments Measure Up PowerPad III Skrócona instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Przyrządy pomiarowe AEMC instruments Measure Up PowerPad III. AEMC instruments Measure Up PowerPad III 17 stron. Power quality analyzer
Drukuj stronę
PARAMETER
Probes and Ratios
Capture Mode
Trend Mode
Alarm Mode
Erase Memory
About
Getting Started
NOTE:
Make sure the PowerPad
Connecting:
• Start the instrument by pressing the
• Configure the instrument to obtain the required results and type of network.
• Connect the current leads and sensors to the PowerPad
• Connect the ground and/or neutral lead to the network ground and/or neutral (when
distributed), as well as the corresponding current sensor.
• Connect the L1 phase lead to the network L1 phase, as well as the corresponding
current sensor.
• Repeat the procedure for phases L2, L3 and N.
Disconnecting:
• Proceed in the reverse order to connecting, always finishing by disconnecting the
ground and/or neutral (when distributed).
• Disconnect the leads and press the
• Recharge the battery, if necessary.
Defines the type of current probe to connect
• MN93: 200 A
AC
• MN193: 100 A or 5 A
• SR193: 1000 A
AC
• J93: 3500 A
/5000 A
AC
• *AmpFlex
Sensors: 100 A/6500 A/10,000 A
®
• *MiniFlex
Sensors: 100 A/6500 A
®
• MR193: 1000 A/1200 A
• SL261: 100 A (sensitivity 10 mV/A
10 A (sensitivity 100mV/A
• 5 A three-phase adapter (3-channel only)
* AmpFlex
and MiniFlex
®
the frequency. A high current at high frequency can saturate the instru-
ment's input.
Configures the voltage and current thresholds
Selects the parameters to record (up to 4 configurations)
Defines the parameters of an alarm
Deletes configurations, alarm settings, snapshots and recordings
Displays the serial number, software and hardware version
®
FUNCTION
(with variable ratio)
AC
DC
AC
AC/DC
AC/DC
AC/DC
have output voltages that are proportional to
®
is fully charged before use.
button.
button to turn the instrument off.
AC
)
)
.
®