Epson Endeavor VL Specyfikacje - Strona 11

Przeglądaj online lub pobierz pdf Specyfikacje dla Pulpit Epson Endeavor VL. Epson Endeavor VL 12 stron.

Drukuj stronę

Installation/Support Tips

Installing Diskette Drives

Make sure that the drive type has been correctly selected in

the SETUP program.

Installing Hard Disk Drives

type table to select the correct type number for the drive.

If the parameters for your drive are not listed, you can

define your own drive type by selecting drive type 47 and

entering the drive's exact parameters for this userdefined

drive type.

controller be used if you are installing a drive that cannot

use the embedded IDE interface. If you install a non-IDE

hard disk drive and controller card, use the SETUP

program to disable the built-in IDE hard disk drive

interface.

Software Problems

try the installation at high speed. If this does not work

properly, select low speed by pressing

loading the program at low speed and then switching to

high speed, if possible.

Cl When using a software package that uses a key disk as its

copy-protection method, try loading it at high speed. If

this does not work, load it at low speed.

Booting Sequence

If you cannot boot the computer from the hard disk, make

sure the booting sequence in SETUP is set to A: then C : .

Then boot the computer from a system diskette in drive A.

Password

Make sure that you do not forget the password you set up. If

you do:

1. Disable the password by setting DIP switch 4 on the main

system board to ON.

2. Then turn the computer on, wait 20 seconds, and turn it

off again.

3. Set

DIP switch

to OFF to enable the password function.

4. Run SETUP to enter a new password, if desired.

You can also enter a hot key designation in SETUP to secure

the system from unauthorized users. Once a password and

hot key have been set, when the hot key is pressed, the

keyboard and mouse lock until the user enters the password.

Information Reference List

Engineering Change Notices

None.

Technical Information Bulletins

None.

Product Support Bulletins

None.