Motorola Halo+ Faq

Przeglądaj online lub pobierz pdf Faq dla Elektroniczna niania Motorola Halo+. Motorola Halo+ 3 stron.

FAQ

How can I add (pair) a camera?

1. Press the M button and the menu bar will pop up.

2. Press the < LEFT button or > RIGHT button until is highlighted, and the del/ add/ view/ scan menu will

pop up.

3. Press the + UP button or - DOWN button to select add, and press the O button to confirm.

4. Camera will pop up, press the + UP button or - DOWN button to select the desired Camera, and press

the O button to start searching for a camera unit.

Note: If a camera is currently paired with the Parent Unit, its camera location (with a * against it) cannot

be selected for a new registration.

5. Press and hold the PAIR button on the underside of the Baby Unit until the Parent Unit finds the

camera, beeps and PAIR OK appears on the screen. The video from the camera will then appear.

Note: A camera can only be registered to one Parent Unit at any one time.

How to set up the Baby Unit for desk mode?

When your child is older, the baby unit (camera) can be removed and used without the cot mounting kit.

This is 'Desk Mode'.

Connect the power supply directly into the Baby Unit (camera) when using in desk mode.

1. Connect the DC plug of the power adapter to the Baby Unit (camera) and the other end to a suitable

mains power socket.

2. Slide the POWER ON/OFF switch to the ON position to turn the Baby Unit on.

3. Slide the POWER ON/OFF switch to the OFF position to turn the Baby Unit off.

How can I reset the camera?

If your Camera is moved from one router (e.g. home) to another (e.g. office) or you have Camera setup

issues, then the Camera must be reset. Please reset the Camera with the following procedures:

1. Slide the ON/OFF switch to OFF.

2. Press and hold the PAIR button, then slide the ON/OFF switch to ON.

3. Release the PAIR button when you hear a confirmation beep and wait for the Camera Unit to

complete an internal reset procedure. The LED indicator will turn red and flash slowly when the Camera

Unit is reset successfully.

4. You can add your Camera again by following the steps in section 5.3.3 for Android devices or in

section 5.4.3 for iOS devices.