Motorola E398 series Instrukcja serwisowa - Strona 35
Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Telefon bezprzewodowy Motorola E398 series. Motorola E398 series 44 stron. Tri-band wireless telephone
Również dla Motorola E398 series: Podręcznik użytkownika (31 strony), Arkusz danych (3 strony), Podręcznik użytkownika (29 strony), Podręcznik rozwiązywania problemów i debugowania (12 strony)
Drukuj stronę
Level 1 and 2 Service Manual
Troubleshooting Chart
Table 4. E389/E399 Telephone: Level 1 and 2 Troubleshooting Chart
Symptom
1. Telephone will not turn on or stay on.
2. Telephone exhibits poor reception or
erratic operation such as calls frequently
dropping or weak or distorted audio.
3. Display is erratic, or provides partial or
no display.
4. Incoming call alert transducer audio
distorted or volume is too low.
5. Telephone transmit audio is weak.
(usually indicated by called parties
complaining of difficulty in hearing voice).
6809480A37-O
Probable Cause
a) Battery either discharged or
defective.
b) Battery terminals open or
misaligned.
c) Transceiver board defective.
a) Antenna defective.
b) Transceiver board defective.
a) Transceiver board connections
faulty.
b) Display assembly defective.
c) Transceiver board assembly
defective.
a) Speaker assembly defective
b) Faulty transceiver board assembly. Replace the transceiver board assembly (refer
a) Microphone defective.
April 21, 2004
Verification and Remedy
Measure battery voltage across a 50 ohm
(>1 Watt) load. If battery voltage is <3.25 Vdc,
recharge the battery using the appropriate
battery charger. If battery will not recharge,
replace the battery. If battery is not at fault,
proceed to b.
Visually inspect battery terminals on both the
battery and the telephone. Realign and, if
necessary, either replace the battery or refer to
a Level 3 Service Center for battery connector
replacement. If battery terminals are not at fault,
proceed to c.
Remove the transceiver board assembly.
Substitute a known good transceiver board and
temporarily reassemble the phone. Press the
Power/End key; if phone turns on and stays on,
disconnect the dc power source and reassemble
the phone with the new transceiver board. Verify
that the fault has been cleared.
Check connection between the antenna and the
transceiver board. If the connection is OK,
substitute a known good antenna. If the fault is
still present, proceed to b.
Replace the transceiver board (refer to 1c).
Verify that the fault has been cleared and
reassemble the phone with the new transceiver
board.
Check general condition of flexible printed cable
(flex). If the flex is good, check that the flex
connector is fully seated. If not, check connector
to transceiver board connections. If faulty
connector, replace the transceiver board
assembly. If connector is not at fault, proceed to
b.
Temporarily replace the display assembly with a
known good assembly. If fault has been cleared,
reassemble with the new display assembly. If
fault not cleared, proceed to c.
Replace the transceiver board assembly (refer
to 1c). Verify that the fault has been cleared and
reassemble the unit with the new transceiver
board assembly.
Temporarily replace the speaker assembly with
a known good assembly. If fault has been
cleared, reassemble with the new speaker
assembly. If fault not cleared, proceed to
to 1c). Verify that the fault has been cleared and
reassemble the unit with the new transceiver
board assembly.
Replace the microphone as described in the
procedures. If fault is not cleared, proceed to b.
Troubleshooting
35