Motorola MaxTrac 300 Instrukcja obsługi - Strona 30
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Radio Motorola MaxTrac 300. Motorola MaxTrac 300 37 stron. 6-frequency conventional fm radio
Również dla Motorola MaxTrac 300: Instrukcja obsługi (2 strony), Podręcznik użytkownika (10 strony)
Drukuj stronę
Non–Locking Trunnion Installation
(1)
Select the location to mount your radio either on the TRANSMISSION HUMP
OR BELOW THE DASH (see Figure 4).
(2)
Using the trunnion-mounting bracket as a template, mark the positions of
the holes on the mounting surface. Use the innermost four holes for a
curved mounting surface such as the transmission hump, and the four
outmost holes for a flat surface such as under the dash.
(3)
Centerpunch the spots you have marked and drill a 5/32" hole at each.
(4)
Secure the trunnion-mounting bracket to the surface with the four (10-
16x3/4") screws provided.
(5)
Place the radio in the trunnion-mounting bracket and secure it with the two
thumb screws provided.
(6)
To complete your radio installation, plug the power cable into the radio
power connector (see Figure 3).
(7)
Mount the antenna using the instructions provided with the antenna kit. Run
the coaxial cable to the radio mounting location. If necessary, cut off the
excess cable and install the cable connector.
(8)
Connect the antenna cable connector to the radio antenna connector on the
rear of the radio (see Figure 3).
(9)
Mount the microphone clip. Follow instructions provided with the
microphone clip.
28
Begin Installation (cont.)
Non-Locking Trunnion Installation
TO BATTERY (+)
VIA FUSE
(RED)
Figure 3. Connections to Rear Radio Panel
ANTENNA
CONNECTOR
TO
DC POWER
ACCESSORY
VEHICLE
CONNECTOR
CONNECTOR
CHASSIS
GROUND
(BLACK)