Motorola Commercial Series Informacje o usłudze - Strona 14

Przeglądaj online lub pobierz pdf Informacje o usłudze dla Przenośne radio Motorola Commercial Series. Motorola Commercial Series 30 stron. Uhf2 (438-470mhz)
Również dla Motorola Commercial Series: Podstawowa instrukcja obsługi (16 strony), Informacje o usłudze (48 strony), Informacje o usłudze (46 strony), Podręcznik użytkownika (18 strony), Podstawowa instrukcja obsługi (12 strony)

1-10

3.3.6

Battery Charging Through Microphone Jack

A wall-type charging power supply may be connected to the 2.5 mm microphone jack (part of

accessory connector J451). The voltage present at the tip contact (pin 4) is applied to the center

charging contact of the battery via diode D470. Another diode, internal to the battery, applies this

voltage to the (+) battery terminal. Only the recommended charger and battery type should be

charged in this manner.

Different battery types contain internal resistors connected from the BATT_CHARGE contact to

ground, which is routed to the microprocessor as BATT_DETECT. A voltage divider is formed with

R255 producing a DC voltage which is read by microprocessor port PE2 (pin 65). This allows the

software to recognize the battery chemistry being used and adjust the battery gauge for best

accuracy. The value of R255 is chosen so that the voltage at the BATT_CHARGE node (cathode of

D470) is never low enough to turn on the EXT_MIC_PTT sense transistor (part of Q470).

3.3.7

Programming and Flashing Through Microphone Jack

The ring contact on the 2.5 mm microphone jack is used for reading, programming or re-flashing the

radio using CPS. This contact (J471 pin 6) is routed to ports PD0_RXD (data into uP, pin 97) and

PD1_TXD (data out of uP, pin 98). Transistor Q410 isolates the input and output functions by

allowing PD1 to pull the line low, but does not affect incoming data from being read by port PD0.

To re-flash the radio (overwrite the software in the Flash ROM with new software), the radio must

power up in the boot mode. This is accomplished by using a flash adapter accessory, which

provides SCI communication with the programming ring contact (J471 pin 6) and also allows a

negative voltage (negative 9 volts dc via a 1K resistor) to be applied to the tip contact (J471 pin 4).

This voltage is sufficient to turn on the base-emitter junction (pins 1 and 2) of Q472 via L471, D471,

VR472 and R471. Pin 6 of Q472 goes high, turning on Q471 (pins 3 and 4) and pulling the

BOOT_ENA line (ports MODA and MODB of the microprocessor) low. Cycling power generates a

reset which causes the radio to boot in the flash mode.

THEORY OF OPERATION