Motorola GP360 Series Informacje o usłudze - Strona 11
Przeglądaj online lub pobierz pdf Informacje o usłudze dla Przenośne radio Motorola GP360 Series. Motorola GP360 Series 30 stron. Professional radio, power distribution and controller
Również dla Motorola GP360 Series: Arkusz specyfikacji (2 strony), Podstawowa instrukcja obsługi (18 strony), Instrukcja obsługi (4 strony), Informacje o usłudze (32 strony), Informacje o usłudze (30 strony)
Drukuj stronę
1.0
Introduction
This Chapter provides a detailed theory of operation for the VHF circuits in the radio. For details of
the theory of operation and trouble shooting for the the associated Controller circuits refer to the
Controller Section of this manual.
2.0
VHF Transmitter
(Refer to Figure 2-1 and the VHF Transmitter schematic diagram)
The VHF transmitter consists of the following basic circuits:
1.
Power amplifier (PA).
2.
Antenna switch/harmonic filter.
3.
Antenna matching network.
4.
Power Control Integrated Circuit (PCIC).
From
VCO
2.1
Power Amplifier
The power amplifier consists of two devices:
1. LDMOS driver IC (U3501)
2. LDMOS PA (Q3501)
The LDMOS driver IC contains two stages of amplification with a supply voltage of 7.3V.
This RF power amplifier is capable of supplying an output power of 0.3W (pin 6 and 7) with an input
signal of 2mW (3dBm) (pin16). The current drain is typically around 130mA while operating in the
frequency range of 136-174MHz.
PCIC
Vcontrol
Power
Amplifier
PA
Driver
Figure 2-1 VHF Transmitter Block Diagram.
THEORY OF OPERATION
Vcontrol
PA Final
Antenna Switch/
Stage
Harmonic Filter
Chapter 2
Antenna
Matching
Network